Hello all,
What's the secret for continuous reports in access, such as continuous feed
labels or receipt printer paper? I'm unsure how access works with the top /
bottom margins, and the page setup (it appears that there isn't a continuous
form paper size). Will access look at the top/bottom margins for each
occurence of a label?
I'm wanting to setup support for dymo roll labels, as well as receipt
printer paper for POS. If the report is set to letter sized, and the label
takes up an inch in height, do you just set the bottom margin to 10" (for an
11" letter size paper)?
And how would you set a receipt type report for a 2.5" continuous roll? And
in this case, will access put in a top / bottom margin once the receipt
reaches the length of a letter sized page (11")?
I'm just not sure how access handles the top/bottom margins in these cases.
Many Thanks,
Andy
What's the secret for continuous reports in access, such as continuous feed
labels or receipt printer paper? I'm unsure how access works with the top /
bottom margins, and the page setup (it appears that there isn't a continuous
form paper size). Will access look at the top/bottom margins for each
occurence of a label?
I'm wanting to setup support for dymo roll labels, as well as receipt
printer paper for POS. If the report is set to letter sized, and the label
takes up an inch in height, do you just set the bottom margin to 10" (for an
11" letter size paper)?
And how would you set a receipt type report for a 2.5" continuous roll? And
in this case, will access put in a top / bottom margin once the receipt
reaches the length of a letter sized page (11")?
I'm just not sure how access handles the top/bottom margins in these cases.
Many Thanks,
Andy